Honda Integra (1986-1989 (DA1-DA4)) Wiper Blades 20 inches / 500 mm + 18 inches / 450 mm + 18 inches / 450 mm Rear Beam Set
Wiper blade sizes guaranteed to fit your vehicle.
What Size Wiper Blades for Honda Integra 1986-1989 (DA1-DA4)?
The correct wiper blade sizes for a 1986-1989 (DA1-DA4) Honda Integra are:
- Driver Side: 20 inches / 500 mm beam blade
- Passenger Side: 18 inches / 450 mm beam blade
- Rear: 18 inches / 450 mm rear wiper
WiperBlade.com.au - Find Your Size
Driver Side
20 inches / 500 mm
Passenger Side
18 inches / 450 mm
Rear
18 inches / 450 mm
Vehicle Details
| Make | Honda |
| Model | Integra |
| Year / Variant | 1986-1989 (DA1-DA4) |
| Kit Type | Front & Rear |
Compatible Variants
Honda Integra 1986-1989 (DA1-DA4) Replacement Wiper Blades
Front & Rear Kit
- Free Delivery Australia-wide
- Perfect Fitment Guarantee
- Premium Quality Wipers
- Easy 30-Second Install
Popular item — selling fast for Honda owners
"Found the right size instantly and the UNIWIPER blades are great quality. Free delivery was a bonus!"
Mark H.
Verified Customer
Why Replace Your Honda Integra Wipers?
Worn wiper blades are more than an annoyance — they're a safety hazard. Here's what happens when you delay replacement.
Dangerous Visibility
Streaks and blind spots reduce your view by up to 40% in rain, especially at night.
Annoying Squeaking
Hardened, cracked rubber scrapes across glass making an irritating noise every sweep.
Wrong Size = Wasted Money
Buying the wrong size means wasted trips and refunds. We guarantee the correct fit for your Honda.
Before
- Streaks and smears blocking your view
- Constant squeaking and juddering
- Replacing every few months
- Guessing which size fits your car
After UNIWIPER
- Crystal clear visibility in all conditions
- Whisper-quiet operation every time
- Premium blades that last 12+ months
- Guaranteed perfect fit for your Honda Integra
Get the Right Wipers in 3 Easy Steps
No guesswork, no wrong sizes, no wasted trips.
Find Your Size
We've already looked it up — your Honda Integra sizes are shown above.
Order from UNIWIPER
Click "Buy Now" to order the exact blades — with free delivery Australia-wide.
Install in 30 Seconds
Simple clip-on design. No tools needed. Clear vision in under a minute.
What Drivers Are Saying
Trusted by thousands of Australian drivers.
"Found the exact size for my Corolla in seconds. Ordered from UNIWIPER and installed in under a minute. Massive upgrade from the cheap ones I had before."
Mark H.
2021 Toyota Corolla • Sydney
"No more squeaking! My old wipers were leaving streaks everywhere. The UNIWIPER blades are whisper-quiet and the free delivery was a nice bonus."
Sarah B.
2019 Mazda CX-5 • Melbourne
"Was always buying the wrong size at the auto store. This site told me exactly what I needed. Perfect fit first time and they last way longer."
James P.
2022 Hyundai Tucson • Brisbane
Our Triple Guarantee
Every UNIWIPER order comes backed by three promises, so you can buy with total confidence.
Perfect Fitment
Guaranteed to fit your Honda Integra or your money back.
Free Delivery
Fast, free shipping to anywhere in Australia. No hidden fees.
Easy Install
Simple clip-on design. No tools, no mechanic. Done in 30 seconds.
Other Honda Integra Variants
Installation Guide for Honda Integra (1986-1989 (DA1-DA4))
Fitting beam wiper blades to your Honda Integra takes about 60 seconds per blade. No tools required.
-
1
Lift the wiper arm
Pull the wiper arm away from the windscreen until it locks in the upright service position. Do this one arm at a time to avoid the arm snapping back onto the glass.
-
2
Release the old blade
Most Honda Integra models use a hook connector. Press the small tab on the underside of the blade, then slide the blade down the arm and off the hook.
-
3
Fit the new beam blade
Match the 20 inches / 500 mm blade to the driver side and the 18 inches / 450 mm blade to the passenger side. Slide the new blade onto the arm hook until you hear it click into place.
-
4
Lower and test
Gently lower the arm back onto the glass. Run the wipers once with a light water spray to confirm smooth, chatter-free contact across the full sweep.
-
5
Rear wiper
Your Honda Integra also has a rear wiper (18 inches / 450 mm). Rear blades typically pull straight off the arm — check the connector type before ordering.
Why Upgrade from Honda Dealership Wipers?
Honda dealerships typically charge $150–$220 for a front pair of wiper blades — often the same rubber compound, at three times the price.
- × $150–$220 per pair
- × Book a service appointment, wait days
- × Labour fee even for a 60-second job
- × Same generic rubber, branded box
- ✓ Exact-fit sizes verified for your Integra
- ✓ Delivered to your door, free Australia-wide
- ✓ Fit them yourself in under a minute
- ✓ OEM-quality beam construction, all-weather rubber
Fitment Guarantee for Integra (1986-1989 (DA1-DA4))
Every size on this page has been cross-referenced against the factory service specification for the 1986-1989 (DA1-DA4) Integra. If a blade doesn't fit, we'll make it right.
Exact-fit verified
Sizes matched to the Integra arm hook and sweep pattern — not a generic year range.
30-day returns
Wrong size, changed your mind, doesn't clear the glass? Send it back within 30 days for a full refund.
Fast Australia-wide shipping
Order today, dispatched today. Metro delivery in 2–3 business days, tracked door-to-door.
Beam vs Traditional Blades for Honda Integra
Modern Honda models ship from the factory with beam-style wiper blades for a reason — here's how they compare to the older frame-and-hinge design.
| Beam Blade (recommended) | Traditional Frame Blade | |
|---|---|---|
| Windscreen contact | Continuous spring-steel pressure across the full length | Pressure at 4–8 hinge points only |
| Highway performance | Aerofoil spoiler holds the blade down at speed | Lifts off the glass above ~90 km/h |
| Cold-weather use | Sealed frame — no hinges to ice up | Exposed joints can freeze and streak |
| Typical lifespan | 12–18 months | 6–9 months |
| Look on a modern Honda | Low-profile, factory-correct | Bulky, dated silhouette |
The blades listed for your Integra above are premium beam-style — the same design Honda fits at the factory. Scroll up to order the exact-fit set.